Been working on the tank rise. It's suppose to expose the top of the motor more and give it a bit of a chopper look.
Most guys just use flat powdered steel plates. But that seems lame... so I picked up these bottle openers.
This is the stock setup. The plastic under the tank holds all the wiring and just eats up that space.
Ditch the plastic garb & expose the wiring situation
Mock up the "brackets"
After a trip to the hardware store
Wire loom to cover those wires, and zip tie them together a bit.
Finish up holding the wires above the backbone where they now go.
The wanted space
Close up. The bottle openers work well for holding the wiring in place.
Finally done
I picked up some of the powder tonight that I need to find time to mount up.