Chopping exhaust on a v twin?

Akilldema · 04-19-2010, 08:25 PM

I'm about to buy a Honda VT700 for dirt cheap and I'm thinking of fabbing some short slash cut open headers for it. Will I need to make major adjustments to the carb?

was92v · 04-19-2010, 10:33 PM

Yes... well not too major. Needles up 1mm, 3 or 4 sizes up on the on the mains and .5-1. turns out on the idle fuel screws should be in the ball park.

04-19-2010, 08:25 PM	#1
Akilldema Canyon Carver Join Date: Feb 2010 Location: Northern VA Moto: FJR1300 Posts: 462	Chopping exhaust on a v twin? I'm about to buy a Honda VT700 for dirt cheap and I'm thinking of fabbing some short slash cut open headers for it. Will I need to make major adjustments to the carb?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

04-19-2010, 10:33 PM	#2
was92v Nowhere Man Join Date: Nov 2008 Posts: 558	Yes... well not too major. Needles up 1mm, 3 or 4 sizes up on the on the mains and .5-1. turns out on the idle fuel screws should be in the ball park.