Garage Door Opener

jtemple · 02-19-2011, 12:30 PM

I have a keychain garage door opener that's about as water resistant as a sock filled with holes. It runs off of an A23 12V battery, and I want to hard wire the guts of it into my bike and mount a switch on the top bar clamp. What I need is some way to make the electronics water resistant. Should I just drill into the case to run wires into it and seal it up with hot glue? Or is there better option?

02-19-2011, 12:30 PM	#1
jtemple Geek Join Date: Feb 2008 Location: Papillion, Nebraska Moto: 2011 Husqvarna TE630 Posts: 1,437	Garage Door Opener I have a keychain garage door opener that's about as water resistant as a sock filled with holes. It runs off of an A23 12V battery, and I want to hard wire the guts of it into my bike and mount a switch on the top bar clamp. What I need is some way to make the electronics water resistant. Should I just drill into the case to run wires into it and seal it up with hot glue? Or is there better option?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode