Go Back   Two Wheel Fix > General > Off Topic

Reply
 
Thread Tools Display Modes
Old 12-06-2009, 10:47 PM   #1
Rangerscott
Viff6N Mutated Warrior
 
Rangerscott's Avatar
 
Join Date: Mar 2009
Location: Texas
Moto: '01 Honda VFR 800 & '09 ER-6N
Posts: 8,704
Default Crap crap crap and more crap

Vehicle: Got a coolant leak at my firewall where the two hoses go to my heater core. Also a main hose is leaking. Starter is going to shit cause the wiring is crappy. I re-used the old gaskets on my T-case and its leaking like a sieve now. My fault on that. I just stuck the new gears in to do a test run and never dropped it again.

Bike: Found some oilish crap plastic behind front wheel, under front wheel plastic, on tire, etc. Pretty sure its not from the bike cause I couldnt find any wet spots. I guess I rode over an oil spill. LOL The main coolant hose that connects both my rads is super soft and crimping itself. Rear brake resevoir is low. All brake pads probably need to be replaced. I dont want to change my fluid until I changed pads but I dont want to spend money on new brakes.

Last edited by Rangerscott; 12-07-2009 at 02:48 AM..
Rangerscott is offline   Reply With Quote
Old 12-06-2009, 10:49 PM   #2
SteveP
Canyon Carver
 
SteveP's Avatar
 
Join Date: Nov 2008
Location: Pensacola, FL
Moto: The v-twin trifecta
Posts: 437
Default

Heater core replacement = the suck

Time to trade it in.
SteveP is offline   Reply With Quote
Old 12-06-2009, 11:03 PM   #3
Rangerscott
Viff6N Mutated Warrior
 
Rangerscott's Avatar
 
Join Date: Mar 2009
Location: Texas
Moto: '01 Honda VFR 800 & '09 ER-6N
Posts: 8,704
Default

Quote:
Originally Posted by SteveP View Post
Heater core replacement = the suck

Time to trade it in.
Haha. I'm sure its just the hoses leaking. I kinda deformed the soft brass ends when I replaced the hoses awhile ago.
Rangerscott is offline   Reply With Quote
Old 12-07-2009, 12:49 AM   #4
ericr
I'm so much cooler online
 
ericr's Avatar
 
Join Date: Nov 2008
Location: Cartersville, GA
Moto: 06 FZ1
Posts: 1,436
Default

Quote:
Originally Posted by Rangerscott View Post
Haha. I'm sure its just the hoses leaking. I kinda deformed the soft brass ends when I replaced the hoses awhile ago.
It's it's leaking in the engine compartment you're golden. If it's leaking inside the car then, new core = the suck
__________________
Redd: No, Im good, I had some ibufrophen

Eric: ibu what?

Quote:
Originally Posted by Rogue View Post
but I'm perfectly placed when I'm on my knees . . . .
ericr is offline   Reply With Quote
Old 12-07-2009, 02:06 AM   #5
tommymac
Moto GP Star
 
tommymac's Avatar
 
Join Date: Nov 2008
Posts: 11,022
Default

Quote:
Originally Posted by SteveP View Post
Heater core replacement = the suck

Time to trade it in.
Big time, I drove around without heat for 2 yrs in my camaro when it went, a guy at the shop told me he would rather eat broken glass than replace one

Hope its just the hose for your sake.

Tom
tommymac is offline   Reply With Quote
Old 12-07-2009, 02:22 AM   #6
Smittie61984
I give Squids a bad name
 
Smittie61984's Avatar
 
Join Date: Mar 2008
Location: Fly Over State
Moto: 1996 CBR600 F3 (AKA the Flying Turd)
Posts: 4,742
Default

Quote:
Originally Posted by SteveP View Post
Heater core replacement = the suck

Time to trade it in.
No shit. My S10 heater core went out and I had to remove my entire inside, dash, steering wheel, etc to get to it. Dumbest part was I had a 1998 S10 and the radiator shop showed 2 kinds of heater cores for S10s. I could get the one from 1980something-1997 or 1999-latest model. 1999+ was $130 and the 1997- was $30. I got the $30 one and the only difference was the two pipes where bent different so I switched the old pipes to the new heater core and it worked perfect.
__________________
lifts - R.I.P.
Smittie61984 is offline   Reply With Quote
Old 12-07-2009, 02:49 AM   #7
Rangerscott
Viff6N Mutated Warrior
 
Rangerscott's Avatar
 
Join Date: Mar 2009
Location: Texas
Moto: '01 Honda VFR 800 & '09 ER-6N
Posts: 8,704
Default

Ya'll are a bunch of non-wrenching wieners! Just more things to add on to the To-Do list.

Going to go get a couple feet of rad hose and some speed bleeders.
Rangerscott is offline   Reply With Quote
Old 12-07-2009, 03:20 AM   #8
101lifts2
WSB Champion
 
101lifts2's Avatar
 
Join Date: Nov 2008
Location: Anaheim, CA
Moto: 2009 Kawi ZX6R
Posts: 5,570
Default

Just bypass the heater core and buy a 12V little car heater.
__________________
Train Hard

Ron Paul - 2012

Mark of Excellence
GM
101lifts2 is offline   Reply With Quote
Old 12-07-2009, 03:40 AM   #9
Rangerscott
Viff6N Mutated Warrior
 
Rangerscott's Avatar
 
Join Date: Mar 2009
Location: Texas
Moto: '01 Honda VFR 800 & '09 ER-6N
Posts: 8,704
Default

Quote:
Originally Posted by 101lifts2 View Post
Just bypass the heater core and buy a 12V little car heater.
I'll get an eskimo to breath on me.
Rangerscott is offline   Reply With Quote
Old 12-08-2009, 05:29 AM   #10
BobTheBiker
too much time on my hands
 
BobTheBiker's Avatar
 
Join Date: Jul 2008
Location: the northern district of god damn
Moto: 01 ZX6R, looking for more now.
Posts: 1,802
Default

heater cores ARENT fun. I swear up and down that when mine starts leaking, I do not care, that shit ISNT getting replaced. I'm absolutely bypassing the heater.
BobTheBiker is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 12:59 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.